Step 1
Layout letters to be populated on flat surface.
Line(s) of LED per stroke are determined as 1 line every 4” stroke, 2 lines of LED for stroke that over 4” under 8” …. and so on.

Step 2
Place the LetterLight pieces in the letter can on the back surface wherever possible to decide the footage and the best possible way to populate for the letter. Place LetterLight in the middle of the stroke if only 1 line is required.  Place LetterLight 1.5” away from stroke edges if more than 1 line is required.

Step 3
Clip LED Modules on to clips and apply double sided tape on the back of the clip. Sheet metal screw or pop rivet is also suitable for securing clips in letters if extra security is desired.

Step 4
Connect LED modules end to end by provided connectors.

( Plug & Play )

Step 5
Clean taping surface before proceeding step 5.

Remove backing from double sided VHB tape and press LED modules firmly into letter can as planned in step 2.

Step 6
Connect only one end of a chain to power source.

For best result, connect two nearest equal footage daisy chains to transformer terminal according to transformer specification.    Such as 13ft chain + 12 ft chain of maximum 25 ft. for each 12V's terminal.

Step 7
If necessary, daisy chain could be formed from next available letter.

Step 8
601-12  Transformer   12V 60W, Max. 25 ft.
601-24  Transformer   24V 72W, Max.  20 ft.
Secondary (output) wires are color coded as Blue and Red. 
No polarity matching is required.