| |
 Neo-Light
NeoLight
vs Neon
Wiring
Instructions
Corner
Options
Neo-Light: Designed
as an alternative for neon
border applications.
Proved and tested for cold weather use in Canada . Will not dim. Neo-Light is easily installed on any surface with minimal surface
penetration and is built to withstand the harshest environments.
Unlike invasive wall penetrations required by neon installations,
Neo-Light's wiring can be accommodated through 1/4" conduit.
A transformer is needed every 60 to 100 feet. Neo-Light can be
easily cut in the field to conform to any architectural requirement.
When mounting buttons are installed, Neo-Light will easily slide
or snap into position. Neo-Light
lengths: 1', 2', 4', 6', and 8' foot lengths
and can be cut at 3" inch increments. NeoLight
has 20 to 25 lights per 12" depending on the color. Colors: Red, Green, Blue, Yellow, and Orange .
Size: 1"wide x 1 3/8"high
|
This is a cross section of
the blue tube with the light in place.
The slot at the base is for installation.
End Caps come with each strip ordered. The end caps
are soft, transparent, flexible plastic plugs that seal
the ends and keep out dust, insects and water. It also
allows the light to transmit between the ends of different
sections to keep the light continuous and seamless. This
also allows for expansion and contraction. |
|
|
Above is a red light PC board.
The red color codes the color of the lights.
These PC boards are slid into the extrusion tube of
the same color to make the color of the light more intense.
|
Shown with wire connector, mounting button and flexible end cap.
|
End caps: #EC-OX
, Colors: R,O,Y,B,G,W 
Shown are the Yellow and Red endcaps. They are made of a soft rubber
material to allow for expansion and contraction. They are translucent
to transmit light from one tube to the other so there are no "dead" spots
without light. They are glued into place when you receive the light strip.
The slot in the Amber one is for the wire feed to connect one 8 ft. length
to the next. |
 Buttons
for mounting NeoLight: Shown with a mounting screw. These
can be mounted onto any interior or exterior surface. The
NeoLight can then be slid or snapped onto the button.
Size: 3/4" R. x 1/2" H
 
|
• LED border tubing
system replaces Neon.
• Consumes 80% less power.
• 5 year warranty on the LED .
• 10 year warranty on the transformer.
• Made with UV protected Plastic.
• Each tube is water sealed.
• UL and Canadian approved.
• Daytime color is the same as nighttime color.
• Comparable illumination to neon border tubing.
• Operates in both extremes of temperature.
• Installs without making multiples of large holes in the building.
• Total Installation cost similar to neon.
• Approved for use by many national accounts.
• Available in red, orange, yellow, green, and blue.
• Used with our UL listed class 2 low voltage transformers. |
100,000 long hours of life!
(24 hours a day for 11.4 years)
10 year warranty on Power Supplies
5 year warranty on Neo-Light Products
5 year warranty on Letter-Light products |
